The purpose and installation of the transponder by pass kit（AS-131）

Purpose：

Some brands vehicle have pre-installed immobilize system in order to avoid to do engine start successfully if the driver doesn’t put the chip-embedded key into ignition switch. Because of immobilize system designated, it’s no use and can’t enjoy the remote engine start feature。

The transponder by pass kit was designed for NOT ONLY enjoy advantage of doing remote engine start, BUT ALSO remain original immobilize system protection simultaneously。

Harness wire installaion：

1. Black wire connects with special designated wire (-) negative when running from remote system。For example black/red wire。

2. Red wire connect with Ignition (+) positive。

3. Gray wire transponder signal。

4. Gray wire transponder signal 。

5. Coil loom signal part。

Installation Step 1：

To open the transponder by pass kit box and put the original chip into the coil of this box. （PS：Some of chip-embedded key can’t be separated，just put full key into the coil of this box）。

Installation step 2：

Method 1：Parallel with original immobilize circuit：Connecting 5. Coil loom with 3&4 Gray wires and install the coil into ignition switch，please refer to illustration A。

Illustration A

Method 2：Due to the transponder signal of some vehicles is weak

For this kind of vehicle，please cut one of wire of transponder signal and connect it with 3 & 4 Gray wires directly without the coin loom，please refer to illustration B。

Illustration B